ass日本风韵熟妇pics男人扒开女人屁屁桶到爽|扒开胸露出奶头亲吻视频|邻居少妇的诱惑|人人妻在线播放|日日摸夜夜摸狠狠摸婷婷|制服 丝袜 人妻|激情熟妇中文字幕|看黄色欧美特一级|日本av人妻系列|高潮对白av,丰满岳妇乱熟妇之荡,日本丰满熟妇乱又伦,日韩欧美一区二区三区在线

冷藏車降溫數學模型建立與影響因素分析
CSTR:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金資助項目(51008087,、71172077)和韶關市科技計劃資助項目(2011CX/K14)


Establishment of Cooling Mathematical Model and Analysis of Influence Factors for Refrigerated Trucks
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    基于動態熱平衡理論,建立了冷藏車廂內溫度隨時間變化的降溫數學模型,并對所建模型進行了相應的試驗驗證,進而分析了冷藏運輸過程中相關參數對降溫性能的影響。研究結果表明:冷藏車廂制冷降溫過程中,,車廂內的溫度隨時間的變化呈指數規律下降;車廂體隔熱材料厚度減小、制冷機組制冷量減小,或車廂體隔熱材料熱導率增大,、車廂外表面對太陽輻射的吸收系數增大、車速加大,、車廂漏氣倍數增大,、貨物呼吸熱增大等均會導致車廂內降溫所需時間延長,,反之,車廂內降溫所需時間將縮短,,且以車廂體隔熱材料的熱導率,、制冷機組制冷量、運輸貨物產生的呼吸熱對冷藏車降溫所需時間影響最大,;當車廂體隔熱材料熱導率每增加0.001W/(m·K)時,,等同需要將車廂體隔熱材料增加5 mm厚度;當車速在0~40 km/h內任意車速條件下行駛時,,降溫所需時間變化不大,,而當車速在40~80 km/h范圍內不同車速條件下行駛時,隨著車速的提高降溫所需時間將明顯延長,;車廂內空氣流速對車廂內空氣的降溫快慢幾乎沒有影響,。

    Abstract:

    In order to improve and enhance the cooling performance of the refrigerated trucks, a mathematical model of cooling process was established in a refrigerated compartment based on dynamic thermal equilibrium theory, by considering heat transfer of the external sol-air temperature through the compartment structure, air and water vapor leakage, and respiratory heat of goods within the refrigerated compartment. The correctness of mathematical model was proved by test. The test results showed that the air temperature decreased exponentially with time during the cooling process of air in refrigerated compartment. The cooling time increased when the thickness of compartment insulation material or cooling capacity of refrigeration system was reduced, or the thermal conductivity of compartment insulation material, solar radiation absorption coefficient of the compartment external surface, vehicle speed, leakage ratio of the compartment, respiratory heat of goods were increased. On the contrary, cooling time would decrease. The thermal conductivity of compartment insulation material, cooling capacity of refrigeration system, and respiratory heat of goods were thought to be the most influential factors. Besides, when the thermal conductivity increased 0.001 W/(m·K), the thickness of compartment insulation material would be required to increase 5 mm on the insulation capacity. The cooling time kept basically unchanged when vehicle speed in the range of 0~40km/h. However, the cooling time would be significantly extended along with the vehicle speed increase in the range of 40~80 km/h. The cooling time was not influenced by the air velocity within refrigerated compartment. 

    參考文獻
    相似文獻
    引證文獻
引用本文

李錦,謝如鶴,劉廣海,呂寧,陳遙烽.冷藏車降溫數學模型建立與影響因素分析[J].農業機械學報,2013,44(6):175-182. Li Jin, Xie Ruhe, Liu Guanghai, Lü Ning, Chen Yaofeng. Establishment of Cooling Mathematical Model and Analysis of Influence Factors for Refrigerated Trucks[J]. Transactions of the Chinese Society for Agricultural Machinery,2013,44(6):175-182.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期: 2013-05-28
  • 出版日期:
文章二維碼