ass日本风韵熟妇pics男人扒开女人屁屁桶到爽|扒开胸露出奶头亲吻视频|邻居少妇的诱惑|人人妻在线播放|日日摸夜夜摸狠狠摸婷婷|制服 丝袜 人妻|激情熟妇中文字幕|看黄色欧美特一级|日本av人妻系列|高潮对白av,丰满岳妇乱熟妇之荡,日本丰满熟妇乱又伦,日韩欧美一区二区三区在线

拖拉機自動駕駛轉向輪角檢測方法
CSTR:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家重點研發計劃項目(2017YFD0700404)和廣東省科技計劃項目(2016B020205003)


Detection Method of Steering Wheel Angle for Tractor Automatic Driving
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    以雷沃M904-D型輪式拖拉機為研究平臺,,采用WYH-3型無觸點角度傳感器,,研究了輪式拖拉機轉向輪角的標定和檢測方法,。介紹了拖拉機轉向輪角度傳感器的安裝方法;采用帶標度的轉盤標定了角度傳感器與拖拉機轉向輪角之間的關系,,標定結果表明,兩者線性關系顯著,相關系數超過0.99。對輪角測試中存在的誤差進行分析,,提出基于最小二乘原理的轉向輪角零位偏差估計方法,,以估計車輪相對零位偏差。路徑跟蹤試驗結果表明,,其橫向跟蹤偏差的絕對值極值為2.74cm,,偏差絕對值的平均值為0.49cm,標準差為0.58cm,。提出的輪式拖拉機轉向輪角測量模型在路徑跟蹤控制應用中表現出較好的效果,,驗證了轉向輪角測試方案的可行性與準確性。

    Abstract:

    Steering wheel angle detection is one of the key technologies to realize automatic navigation of agricultural machinery. The measurement results of agricultural machinery steering wheel angle directly affect the accuracy of automatic navigation control and the effect of agricultural machinery operation. Taking the Lovol M904-D wheeled tractor as the research platform, the WYH-3 noncontact angle sensor was used to study the calibration and detection method of steering wheel angle of wheeled tractor. The installation method of tractor steering wheel angle sensor was introduced. The relationship between angle sensor and agricultural machine steering angle was calibrated by scaled dial. The calibration results showed that the correlation was significantly and the coefficient was over 0.99. Focusing on the bias error in the wheel angle calibration test, a curve optimization fitting method based on the least squares principle was proposed to estimate the position deviation of the wheel relative to 0°. Preview tracking model based path tracking test showed that the extreme value of navigation control deviation was 2.74cm, the average absolute value of deviation was 0.49cm, and the standard deviation was 0.58cm. It indicated that the path tracking control precision was high, and the feasibility and accuracy of the steering wheel angle detection scheme were verified. 

    參考文獻
    相似文獻
    引證文獻
引用本文

張智剛,王桂民,羅錫文,何杰,王進,王輝.拖拉機自動駕駛轉向輪角檢測方法[J].農業機械學報,2019,50(3):352-357. ZHANG Zhigang, WANG Guimin, LUO Xiwen, HE Jie, WANG Jin, WANG Hui. Detection Method of Steering Wheel Angle for Tractor Automatic Driving[J]. Transactions of the Chinese Society for Agricultural Machinery,2019,50(3):352-357.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2019-01-01
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期: 2019-03-10
  • 出版日期: 2019-03-10
文章二維碼