ass日本风韵熟妇pics男人扒开女人屁屁桶到爽|扒开胸露出奶头亲吻视频|邻居少妇的诱惑|人人妻在线播放|日日摸夜夜摸狠狠摸婷婷|制服 丝袜 人妻|激情熟妇中文字幕|看黄色欧美特一级|日本av人妻系列|高潮对白av,丰满岳妇乱熟妇之荡,日本丰满熟妇乱又伦,日韩欧美一区二区三区在线

基于模糊PID的頂夾式取苗裝置苗盤定位控制方法
CSTR:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

湖南省智能農機裝備創新研發項目


Control Method for Seedling Tray Positioning in Top-clamping Seedling-taking Device Based on Fuzzy PID
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    針對頂夾式取苗裝置苗盤精確輸送定位的需求,提出了一種基于模糊 PID 與結合雙傳感器的苗盤精準定位控制方法,。該方法通過激光傳感器感知苗盤到位信息;通過角度傳感器獲取苗盤實時位置對應的角度信息;通過以兩相混合式步進電機為對象建立的步進電機轉角模糊 PID 控制模型對苗盤進行精確輸送,。以128穴標準育苗盤為輸送對象,進行苗盤輸 送定位精度分析,,結果表明,,苗盤輸送定位誤差應小于2.13 mm,對應角度控制誤差應小于2.03°,。然后,,根據頂夾式取苗裝置工作原理,分析建立了苗盤輸送定位控制系統,。仿真試驗表明,,在獲得的最優 PID 控制參數 KP=40、KI=76,、KD=3.2 下,,模糊 PID 控制調節時間為 0.18 s,,受擾動后恢復時間 0.31 s,響應最大變化量為 0.94°, 小于2.03°, 動態性能與穩態性能均優于經典 PID,,滿足控制精度需求,。輸送定位控制試驗結果表明,模糊 PID 控制定位平均誤差為 0.32 mm,,定位平均相對誤差為 0.92%,,最大定位誤差為 0.53 mm,小于2.13mm,,滿足苗盤輸送位置精確定位需求,。該方法提升了系統抗干擾能力,為蔬菜自動移栽機關鍵技術升級提供了技術支撐,。

    Abstract:

    In response to the demand for precise conveying and positioning for seedling trays in top-clamping seedling-taking devices, an accurate positioning control method based on fuzzy PID and dual sensors was proposed, which obtained the position information of seedling trays by a laser sensor and got corresponding angle information by an angle sensor. Moreover, a fuzzy PID control model based on a two-phase hybrid stepper motor was established to convey the seedling trays accurately. Taking the standard 128-cell seedling tray as the conveying object, the positioning accuracy of the seedling tray was analyzed, which showed that the positioning error of the seedling tray should be less than 2.13 mm, corresponding to the angle control error of less than 2.03 °. Subsequently, the control system for seedling tray positioning was analyzed and established based on the working principle of the top-clamping seedling-taking device. The simulation results showed that under the optimal PID parameters, KP=40, KI=76, KD =3.2, the adjustment time of fuzzy PID control was 0.18 s, the recovery time after disturbance was 0.31 s, and the maximum response variation was 0.94 °, which was less than 2.03 °. The fuzzy PID had a better dynamic and steady-state performance than the classical PID, meeting the control requirements. The positioning control results showed that the fuzzy PID achieved an average positioning error of 0.32 mm, an average relative positioning error of 0.92%, and a maximum positioning error of 0.53 mm, which was less than 2.13 mm. This method can meet the requirements for precise positioning of seedling tray conveying, enhancing the system′s anti- interference capability and providing a reference for the key technology upgrade of automatic vegetable transplanters.

    參考文獻
    相似文獻
    引證文獻
引用本文

孔德航,張學東,崔巍,吳海華,孫星,王志偉,王春雷,寧義超.基于模糊PID的頂夾式取苗裝置苗盤定位控制方法[J].農業機械學報,2024,55(s1):207-216,,229. KONG Dehang, ZHANG Xuedong, CUI Wei, WU Haihua, SUN Xing, WANG Zhiwei, WANG Chunlei, NING Yichao. Control Method for Seedling Tray Positioning in Top-clamping Seedling-taking Device Based on Fuzzy PID[J]. Transactions of the Chinese Society for Agricultural Machinery,2024,55(s1):207-216,229.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2024-07-16
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期: 2024-12-10
  • 出版日期:
文章二維碼